This is a very common issue with newer refrigerators.
Lg french door freezer not making ice.
The power switch is located on the icemaker and is marked on and off.
To check the evaporator fan motor open the freezer door and then manually activate the freezer door switch.
Unplug the unit and remove all food and ice from the ice bin.
Open the refrigerator door.
Without filter or when the filter installed not properly in the filter housing water will not flow to the ice maker and water dispenser.
How to manually defrost your refrigerator.
If the freezer temperature is too high ensure that the condenser coils are clear of debris and the condenser fan is working properly.
Discover lg french door.
Leave the doors open and wait at least 8 hours for the refrigerator to defrost.
If the water filter is not installed correctly the water will not flow and therefore no ice or water will come from the dispenser.
The water supply is turned on and no kinks should be in the lines.
The water filter on newer refrigerators need to be twist locked into place.
Fan motor will not run when the door is open.
If the door switch is activated but the evaporator fan motor won t run replace the evaporator fan motor.
Open the ice compartment by gently pulling the handle downward.
To reset the ice maker make sure that.
Water filter if during the test mode your ice maker didn t fill with water then check your water filter.
Ice maker and water dispenser troubleshooting refrigerator.
Use a multimeter to check the current flow and power levels.
If the freezer temperature is above 10 degrees fahrenheit 12c the ice maker will not produce ice cubes efficiently.
This test fill button will be on the ice maker itself.
The freezer temperature should be set between 0 and 5 degrees fahrenheit 18 to 15c for the ice maker to work properly.
When the psi falls below this level the lg refrigerator may still produce water at a slower rate but it will not supply ice.
Why lg refrigerator ice maker not filling with water.
A spotless clean.
It is not the cubed ice selection button on the control panel.
Make sure to keep towels in and around the unit to soak up any excess water after the frost melts.
If the figure is under 20 psi you ll need to increase the flow by turning the value.
On most refrigerators the.
Set the ice maker switch to on or off.